![]() Remove the anti-scale valve (or set the control to self-clean/autoclean depending on the model). Unplug the iron then hold your iron horizontally above the sink. Place the iron on its heel and leave to heat up for around 5 minutes. Set the thermostat control to Max and the steam control on DRY and switch on. How do I prevent the steam holes of my iron from clogging up?įirstly, fill the iron tank to MAX with water. Be careful! Do not hold the valve at the edges. Then rinse it with plenty of water and put it back inside the iron.Put the valve into a glass of lemon juice (or white vinegar) for 4 hours.Empty the water and remove the valve, holding it by the top.Unplug the iron and leave it to cool for 30-45 minutes.If your iron has an anti-calc system, you should clean the anti-calc valve once a month. Maintenance and cleaning How do I clean the anti-calc valve on my iron? We recommend that you start with fabrics to be ironed at a low temperature. Important: The iron takes longer to cool down than to heat up. If ironing mixed-fibre fabrics, set the temperature for the most fragile fibre. We would advise ironing dark clothes inside out and using the correct temperature. Shiny marks can appear on some fabrics, especially on dark coloured fabrics. Never clean your iron's soleplate with abrasive or metallic pads.Avoid ironing over abrasive items (buttons, zip fastenings, etc.).Always place your iron on its heel rest or its base (depending on model).To avoid damaging the soleplate, follow this advice: How can I avoid scratching the soleplate of my iron? No, you must always unplug the iron before filling it. Can I fill the iron with water when it is plugged in? If it has not been used for a long time (for example several weeks), use it over the sink for a few minutes to remove any residue that could stain your laundry. What should I do if my iron has not been used for a long time? ).Īt the end of your ironing session, we would suggest that once your iron has cooled down, you should wipe over the soleplate and around the steam holes to remove any burned fibers that may have started collecting around the steam holes.Set the variable steam control to Dry and set the temperature to suit the type of material (care points Yes and you do not need to fill the tank with water. Note: Never use the vertical steam function on an item being worn by anyone. Press the steam control button intermittently and move the iron from top to bottom.Īs the steam produced is very hot, it softens the fibres and removes creases.Leave the item on a hanger and gently pull the fabric with one hand.To do this, set the iron temperature button to the maximum position. This function allows you to iron fabrics in situ or on a hanger. What is the vertical steam function used for? How do I use it? Use steam only when the iron is hot (the light must be off). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |